Manual Selector Assembly - Suzuki sq-416-420-625 Service Manual

7B1-62 AUTOMATIC TRANSMISSION (4 A / T)

MANUAL SELECTOR ASSEMBLY

Type-1
Tightening Torque
.
(a): 18 N m (1.8 kg-m, 13.5 lb-ft)
1. Manual selector assembly
(Select lever assembly)
2. Manual lever assembly
3. Select cable bracket
4. Select indicator
5. Slide cover
6. Select lever knob
Type-1
1. Interlock cam pin
(only for new selector assembly)
7. Spring
8. Knob button
9. Shift lock solenoid rod
10. Shift lock solenoid
11. Cover
12. Illumination lamp
13. Interlock cam
REMOVAL
1) Disconnect negative cable at battery.
2) Remove console box.
3) Disconnect connector for illumination lamp, shift lock solenoid
4) Disconnect interlock cable from interlock cam of selector as-
5) Remove selector assembly mounting bolts.
6) Disconnect select cable from lever of selector assembly.
INSTALLATION
NOTE:
New selector assembly of Type-1 is supplied with held inter-
lock cam at interlock cable connecting position with pin. Re-
move this pin after connecting interlock cable to interlock cam
and tightening cable nut.
Reverse removal procedure to install noting the followings.
D Connect interlock cable end to cam referring to steps 2) to 8) of
D Upon completion of installation, confirm that brake (key) interlock
Type-2
and overdrive OFF switch.
sembly.
"Interlock Cable Installation" section.
system operates properly.
1. Manual lever
assembly
2. Select indicator
assembly
3. Illumination lamp
assembly
4. Bulb filter
5. Bulb
6. Knob assembly
7. Shift lock solenoid