3E-16 REAR SUSPENSION
1. Wheel speed sensor
2. Wheel speed sensor coupler
3. Wheel speed sensor harness clamp
4. Wheel speed sensor harness
REAR AXLE HOUSING
REMOVAL
1) Drain differential gear oil.
2) Remove rear brake drum. (Refer to steps 1) to 5) of BRAKE
3) Disconnect brake pipe from wheel cylinder. With right side wheel
1. Brake pipe flare nut
2. Brake pipe
3. Brake back plate
4) For vehicle with ABS, disconnect wheel speed sensor coupler
5) Remove rear wheel bearing retainer nuts from rear axle hous-
1. Nut
6) Check to ensure that there is clearance between rear wheel
1. Bearing retainer
2. Parking brake shoe
lever
3. Clearance
Carry out steps 2) to 7) and 15) to 18) on both right and left
wheels.
Note that left wheel and its related parts are used in illustrations
in this section.
DRUM REMOVAL.)
cylinder, disconnect 2 brake pipes.
and remove wheel speed sensor with its harness.
ing.
bearing retainer and parking brake shoe lever. If no clearance
is found, loosen cable locking nut further to obtain clearance.