Suzuki sq-416-420-625 Service Manual page 197

1. Steering shaft joint
2. Steering shaft (column side)
3. Marks
1. Steering shaft joint
2. Bolt (column side)
3. Bolt (lower shaft assembly side)
1
1. Steering column hole cover
4) Install steering shaft joint to steering shaft by matching it to
marks made before removal.
5) Install shaft joint bolt (column side) to steering shaft joint. Tighten
shaft joint bolt (column side) to specified torque first and then
shaft joint bolt (lower shaft assembly side) to specified torque.
Tightening Torque
.
(c): 25 N m (2.5 kg-m, 18.0 lb-ft)
6) If contact coil and combination switch assembly is removed,
install it, referring to "CONTACT COIL AND COMBINATION
SWITCH ASSEMBLY" in this section.
7) Connect all connectors that have been removed in removal.
8) Install steering column hole cover.
9) If steering wheel is removed, install it by referring to "STEER-
ING WHEEL" in this section.
10) Connect negative battery cable.
11) After installing steering column assembly, be sure to enable air
bag system by referring to "ENABLING AIR BAG SYSTEM" un-
der "SERVICE PRECAUTIONS" in Section 10B.
AIR BAG STEERING WHEEL AND COLUMN 3C1-13