Suzuki sq-416-420-625 Service Manual page 307

5) Apply thin coat of brake fluid to all around new grommets (2pcs.)
and install them to cylinder body, then install reservoir.
6) Set a new pin in reservoir hole and drive it in. At this time, make
end of pin and end face margin of reservoir equal.
1. Pin
2. Reservoir
3. Master cylinder
INSTALLATION
NOTE:
D See NOTE at the beginning of this section.
D Adjust clearance between booster piston rod and primary
piston with special tool, referring to CLEARANCE BETWEEN
BOOSTER PISTON AND MASTER CYLINDER PISTON AD-
JUSTMENT in this section.
1) Install master cylinder to brake booster.
2) Tighten master cylinder attaching nuts to specification.
Tightening Torque
(a): 13 N
3) Connect brake pipes to master cylinder.
D For vehicle with ABS
Tightening Torque
(b): 10 N
4) Tighten flare nuts to specification.
Tightening Torque
(c): 16 N
5) Connect reservoir lead wire.
6) Fill reservoir with specified brake fluid.
7) Check brake pedal play and bleed air from system.
8) Perform brake test and check each installed part for fluid leak-
age.
BRAKES PIPE / HOSE / MASTER CYLINDER 5A-13
.
m (1.3 kg-m, 9.5 lb-ft)
a) Connect brake pipes between master cylinder and ABS hy-
draulic unit.
b) For LH steering vehicle, connect ABS control module con-
nector.
c) For RH steering vehicle, install ABS hydraulic unit bracket
bolts and tighten it to specified torque.
.
m (1.0 kg-m, 7.5 lb-ft)
.
m (1.6 kg-m, 12.0 lb-ft)