Suzuki sq-416-420-625 Service Manual page 477

1. Right side transmission stiffener (if equipped)
G16 / J20
ON LIFT
1. Drain plug
2. Filler and level plug
1. Drain plug
2. Front propeller shaft
1. Match marks
10) Remove torque converter housing lower plate.
11) Holding drive plate stationary with special tool or the like, re-
1) Drain transfer oil for 4WD vehicle or A/T fluid for 2WD vehicle.
NOTE:
If 4WD automatic transmission is overhauled later on,
draining A/T fluid at this point will facilitate work.
Tightening Torque
.
(a): 23 N m (2.3 kg-m, 17.0 lb-ft)
2) Before removing propeller shaft, give match marks on joint
flange and propeller shaft as shown in left figure.
3) Remove universal joint flange bolts and take out rear propeller
shaft.
4) Likewise, take out front propeller shaft. (if equipped)
5) Remove nut from the end of select cable and bracket to set
cable free.
6) Remove select cable bracket by removing its 2 bolts.
7) Remove exhaust No.1 and No.2 pipe.
8) Remove transmission stiffener (right side) if equipped.
9) Unclamp and disconnect oil cooler hoses from pipes.
NOTE:
To avoid leakage of transmission fluid, plug open ends of
oil cooler pipes and hoses right after they are discon-
nected.
move torque converter mounting bolts with wrench.
Special Tool (only for G16/J20)
(A): 09927-56010
AUTOMATIC TRANSMISSION (4 A / T) 7B1-75