Suzuki sq-416-420-625 Service Manual page 176

3C-6 STEERING WHEEL AND COLUMN
1. Steering column hole cover
*
: If equipped
1. Steering column assembly
2. Steering shaft joint
3. Marks
1. Steering column assembly
2. Steering shaft joint
3. Steering lower shaft assembly
4. Bolt (column side)
5. Bolt (lower shaft assembly side)
2) Remove steering wheel and combination switch, if necessary.
Refer to "STEERING WHEEL" and "COMBINATION SWITCH"
in this section.
Perform the following procedure if not removing steering wheel
and/or combination switch.
i) Turn steering wheel so that vehicle's front tires are at straight-
ahead position.
ii) Turn ignition switch to "LOCK" position and remove key.
3) Remove steering column hole cover.
4) Disconnect all connectors for the following parts.
D Combination switch
D Ignition switch
D Immobilizer control system parts (if equipped)
5) Make alignment marks on shaft joint and shaft (column side) for
a guide during reinstallation.
6) After removing bolt on column side of shaft joint and loosening
bolt on its lower shaft assembly side, move shaft joint to lower
shaft assembly side (in arrow direction in the figure).