Suzuki sq-416-420-625 Service Manual page 222

3D-20 FRONT SUSPENSION
(a)
1. Hub cap
2. Wheel hub
1. Axle shaft drive flange
2. Bolt
D Tighten control arm ball stud nut
When tightening ball stud nut, use new nut and tighten it to speci-
fied torque.
Tightening Torque
.
(a): 60 N m (6.0 kg-m, 43.5 lb-ft)
D For 2WD vehicle
Apply water tight sealant to mating surface of wheel hub and
install hub cap to wheel hub.
"A": Sealant 99000-31090
D For 4WD vehicle
When installing axle shaft drive flange to wheel hub, apply sealant
to mating surface of axle shaft drive flange.
"A": Sealant 99000-31090
Tightening Torque
.
(a): 50 N m (5.0 kg-m, 36.5 lb-ft)
D For installation procedures of wheel hub component, refer to
"WHEEL HUB (INCLUDED WHEEL BEARING)" in this section.
D Connect tie-rod end to knuckle and tighten new tie-rod end nut.
Tightening Torque
.
(a): 43 N m (4.3 kg-m, 31.5 lb-ft)
D For any tightening torque other than those specified in text, refer
to "TIGHTENING TORQUE SPECIFICATION" in this section.