Suzuki sq-416-420-625 Service Manual page 794

10B-88 AIR BAG SYSTEM
1
NOTE:
The remaining steps are to be followed in the unlikely event
that the seat belt pretensioner did not activate after following
these procedures.
23) Ensure that the deployment harness has been disconnected
from the power source and that its two banana plugs have been
shorted together by fully seating one banana plug into the oth-
er.
24) Disconnect the deployment harness from the seat belt preten-
sioner.
WARNING:
D For handling and storage of a live seat belt pretensioner,
select a place where the ambient temperature below 658C
(1508F), without high humidity and away from electric
noise.
D Never carry the seat belt pretensioner by the wires or con-
NG
nector on the underside of the pretensioner.
D When placing a live seat belt pretensioner on the work-
bench or some place like that, be sure not to lay it with its
exhaust hole provided side facing down. It is also prohib-
ited to put something on its face with an exhaust hole or
to put a seat belt pretensioner on top of another.
Otherwise, personal injury may result.
1
25) Temporarily store the seat belt pretensioner. At that time, be
sure NOT to face its exhaust hole provided side down. It must
face up. Refer to "Service Precautions" in this section for detail.
26) Contact your local distributor for further assistance.
1. Exhaust hole