Hydraulic Pressure In P/S Circuit; Hydraulic Pressure Check - Suzuki sq-416-420-625 Service Manual

3B1-10 POWER STEERING (P / S) SYSTEM
1. P / S fluid reservoir
2. Attachment
3. Gasket
1. P / S fluid reservoir
2. Gauge valve (open)
3. P / S pump
4. Union bolt
5. High pressure side
6. Low pressure side
4. P / S gear box
5. High pressure side
6. Low pressure side

HYDRAULIC PRESSURE IN P/S CIRCUIT

HYDRAULIC PRESSURE CHECK

1) After cleaning joint of high pressure hose and P/S pump thor-
oughly, disconnect hose from pump and install special tool (oil
pressure gauge, attachment and hose).
Tighten each flare nut to specified torque.
CAUTION:
Take care not to cause damage to A/C condenser during
service operation, if equipped.
Special Tool
(A): 09915-77410 (Oil pressure gauge)
(B): 09915-77420
2) Check each connection for fluid leakage and bleed air.
Refer to "AIR BLEEDING PROCEDURE" in this section.
3) With engine idling, turn steering wheel and warm up engine till
temperature of fluid in P/S fluid reservoir rises to 50 – 60_C (122
– 140_F).
4) Check back pressure by measuring hydraulic pressure with en-
gine idling and hands off steering wheel.
Back pressure: Lower than 1000 kPa (10 kg/cm
When back pressure is higher than specified values, check con-
trol valve and piping for clogging.
2
, 142 psi)