Suzuki sq-416-420-625 Service Manual page 310

5A-16 BRAKES PIPE / HOSE / MASTER CYLINDER
1. Clevis
2. Nut
1. Steering column
2. Push rod clevis
3. Brake pedal arm
BOOSTER PUSH ROD CLEVIS ADJUSTMENT
Install push rod clevis so that measurement "a" is obtained and
torque nut to specification.
Tightening Torque
(a): 25 N
Length
"a": 109.5 – 110.5 mm (4.31 – 4.35 in.)
INSTALLATION
NOTE:
D See NOTE at the beginning of this section.
D Check length of push rod clevis. (Refer to BOOSTER PUSH
ROD CLEVIS ADJUSTMENT.)
D Before installing master cylinder, adjust booster piston rod.
(Refer to CLEARANCE BETWEEN BOOSTER PISTON ROD
AND MASTER CYLINDER PISTON ADJUSTMENT of this sec-
tion.)
D Apply silicone grease to master cylinder piston.
1) Install booster to dash panel as shown. Then connect booster
2) Tighten booster attaching nuts to the specified torque.
3) Connect brake vacuum hose to brake booster.
4. Clevis pin
5. Clip
6. Nut
4) For vehicle equipped with ABS, connect brake pipes to ABS hy-
5) Install master cylinder, referring to MASTER CYLINDER AS-
.
m (2.5 kg-m, 18.0 lb-ft)
push rod clevis to pedal arm with clevis pin and clip.
Tightening Torque
.
(a): 13 N m (1.3 kg-m, 9.5 lb-ft)
draulic unit. If ABS hydraulic unit bracket bolts removed, tighten
flare nuts to specification after installing master cylinder.
Tightening Torque
.
(a): 16 N m (1.6 kg-m, 12.0 lb-ft)
SEMBLY INSTALLATION in this section.