Suzuki sq-416-420-625 Service Manual page 166

3B1-22 POWER STEERING (P / S) SYSTEM
1. Rotor
2. Snap ring
3. Dot
D Check free length of relief valve spring.
Free length: Standard 22.0 mm (0.866 in.)
Replace if any defective is found.
1. Flow control spring
ASSEMBLY
Reverse disassembly procedure for assembly, noting the following.
1) Apply grease to oil seal lip and apply power steering fluid to slid-
1. Oil seal
2. Shaft (pulley)
2) Apply power steering fluid to O-rings and fit them to pump body.
1. O-ring
3) Install side plate to pump body.
1. Side plate
2. Bolt hole
4) Apply power steering fluid to sliding surface of rotor.
5) Install rotor to shaft, directing dot marked side of rotor facing up.
6) Install new snap ring to shaft, then make sure to fit snap into shaft
Limit
ing surface of the shaft then insert pulley's shaft from oil seal side
of the pump body.
"A": Grease 99000-25010
NOTE:
Carefully align the dowel pins on the side plate at bolt hole
as shown in figure.
groove securely.
NOTE:
Never reuse the removed snap ring.
19.0 mm (0.748 in.)