Suzuki sq-416-420-625 Service Manual page 275

Center support equipped vehicle
1) Insert bearing race into yoke, tapping it with a hammer, until it is
flush with yoke face. When doing this, insert spider into bearing
race to prevent rollers in bearing race from coming out.
1. Copper hammer
2. Bearing race
3. Yoke
4. Spider
2) Insert the other bearing race on the opposite side into yoke, tap-
ping with a hammer until it is flush with yoke face.
3) Insert bearing races on the flange yoke side in the same way as
described in 1) and 2) above.
4) Place a metal plate on bearing races when tapping them in to
avoid damaging yoke.
5) Securely fit 4 circlips to shaft and flange yoke.
NOTE:
D After assembly, check to ensure that both shaft yoke and
D Make sure that each circlip is fitted in groove securely.
INSTALLATION
Reverse removal procedure to install propeller shaft.
D Use following specification to torque universal joint flange bolts
(and center support bolts).
Tightening Torque
(a): 50 N
D When installing propeller shaft, align the match marks.
Otherwise, vibration may occur during driving.
NOTE:
If transfer oil was drained for front propeller shaft removal,
pour specified gear oil into transfer case to specified level.
flange yoke move smoothly.
.
m (5.0 kg-m, 36.5 lb-ft)
PROPELLER SHAFTS 4B-5