Upper Rod - Suzuki sq-416-420-625 Service Manual

1. Clamp

2. Upper rod

1. Upper rod front bolt
2. Nut
3. Upper rod
4. Wheel speed sensor
harness bracket
(Toward outside of body)
UPPER ROD
REMOVAL
1) Hoist vehicle and remove rear wheel.
2) If equipped with ABS, disconnect wheel speed sensor harness
3) Remove upper rod.
1. Upper rod
2. Bolt
INSTALLATION
1) Install upper rod to chassis frame and axle housing, referring to
2) See figure for distinction of installing direction of left side upper
3) Connect wheel speed sensor harness clamp to upper rod (if
5. Upper rod rear bolt
6. Washer
7. Body center
8. Front side
4) Lower hoist and with vehicle in non-loaded condition, tighten
clamp from left upper rod.
figure for installing direction of bolts.
Nuts should not be tightened.
rod for vehicle equipped with ABS.
equipped with ABS).
front bolt and rear nut of upper rod to specified torque.
Tightening Torque
.
(a): 90 N m (9.0 kg-m, 65 lb-ft)
REAR SUSPENSION 3E-9