Throttle Position Sensor; Power/Normal Change Switch - Suzuki sq-416-420-625 Service Manual

7B1-66 AUTOMATIC TRANSMISSION (4 A / T)
1
INSTALLATION
Reverse removal procedure to install solenoid valves and noting
the following points.
D For details of solenoid valve installation, refer to "Unit Repair"
D Install oil tubes in such order as shown in figure.
3
D For details of oil pan installation, refer to "Unit Repair" section.
D Tighten universal joint flange bolts & nuts and exhaust pipe brack-
2 D Fill A/T fluid and check fluid level according to procedure de-
D Check for fluid leakage after warming up A/T.
4

THROTTLE POSITION SENSOR

INSPECTION
Refer to SECTION 6E1/6E2 for inspection.

POWER/NORMAL CHANGE SWITCH

INSPECTION
Check Power/Normal change switch for operation referring to Step
4 of Diag. Flow Table B-4 in this section.
If malfunction is found, replace.
section. Use new gasket and O-ring.
Use new oil pan gasket.
et bolts to specified torque.
scribed in "CHANGING FLUID" previously.