On-Vehicle Service; Windshield Wiper And Washer; Front Wiper And Washer - Suzuki sq-416-420-625 Service Manual

Type A
Type B
Type C

ON-VEHICLE SERVICE

WINDSHIELD WIPER AND WASHER

FRONT WIPER AND WASHER

INSPECTION
Front Wiper and Washer Switch (in Combination Switch)
INT
1) Disconnect negative cable at battery.
WASHER
LO 2) Disconnect combination switch lead wire coupler.
ON
3) Check for continuity between terminals at each switch position
HI
as shown below. If check result is not as specified, replace
switch.
Wiper SW
REMOVAL AND INSTALLATION
For vehicle without air bag system, refer to Section 3C COMBINA-
TION SWITCH, and for vehicle with air bag system, refer to Section
3C1 CONTACT COIL AND COMBINATION SWITCH ASSEMBLY.
Wiper Motor
1) As illustrated, use a 12 V battery to connect its (+) terminal to ter-
minal "A", and its (–) terminal to Black lead wire (2) (Type A, B)
or terminal "E" (Type C).
If motor (1) rotates at a low revolution speed of 45 to 55 rpm, it
is proper. For high speed check, connect battery (+) terminal to
terminal "B", and its (–) terminal to Black lead wire (2) (Type A,
B) or terminal "E" (Type C). If motor rotates at a high revolution
speed of 67 to 83 rpm, it is proper.
WINDOWS, MIRRORS, SECURITY AND LOCKS 8D-9
Terminal
B3 B3 +2 +2
OFF
INT
LO
HI
+1 +1 As As
Terminal
Wiper
SW
OFF
ON
B3 B3 W W