[A]
[B]
[A]: Without ABS
[B]: With ABS
1. 4-way joint / 2-way joint
2. Master cylinder
3. LSPV
4. Right brake caliper
5. Left brake caliper
6. Right wheel cylinder
7. Left wheel cylinder
8. ABS actuator
F
2. Vinyl tube (See-through tube)
1. Plug cap
3. Container
CHECK AND ADJUSTMENT
BLEEDING BRAKES
NOTE:
For vehicle equipped with ABS, make sure that ignition switch
turns off.
Be sure to bleed air of brake system according to following proce-
dure when its oil hydraulic circuit has been disconnected.
Hydraulic lines of brake system consists of two separate lines, one
for front wheel brakes and the other for rear wheel brakes.
Air bleeding is necessary at right and left front wheel brakes, left
rear wheel brake and LSPV (if equipped without ABS), i.e. 4 places
(3 places for vehicle with ABS) in all.
: Air bleeding point
1) Fill master cylinder reservoir with brake fluid and keep at least
2) Remove bleeder plug cap.
3) Depress brake pedal several times, and then while holding it de-
CAUTION:
Brake fluid is extremely damaging to paint. If fluid should
accidentally touch painted surface, immediately wipe
fluid from paint and clean painted surface.
one-half full of fluid during bleeding operation.
Attach a vinyl tube to bleeder plug of wheel cylinder, and insert
the other end into container.
pressed, loosen bleeder plug about one-third to one half turn.
BRAKES 5-7