On-Vehicle Service; Steering Wheel - Suzuki sq-416-420-625 Service Manual

ON-VEHICLE SERVICE

STEERING WHEEL

REMOVAL
1) Disconnect negative battery cable at battery terminal.
2) Remove steering wheel pad screw.
3) Remove steering wheel pad and disconnect horn harness.
1. Steering wheel
2. Steering wheel pad
3. Screw
4) Remove steering shaft nut.
5) Make alignment marks on steering wheel and shaft for a guide
1. Steering shaft nut
6) Remove steering wheel with special tool.
1. Steering wheel
INSTALLATION
1) Install steering wheel to steering shaft with 2 lugs on combina-
2) Tighten steering shaft nut to specified torque.
3) Connect horn harness and install steering wheel pad.
4) Tighten steering wheel pad screw.
5) Connect negative battery cable.
1. Lugs
2. Grooves
3. Alignment marks
during reinstallation.
Special Tool
(A): 09944-36011
CAUTION:
Do not hammer the end of the shaft. Hammering it will
loosen the plastic shear pins which maintain the column
length and impair the collapsible design of the column.
tion switch fitted in two grooves in the back of steering wheel and
also aligning marks on steering wheel and steering shaft.
Tightening Torque
.
(a): 33 N m (3.3 kg-m, 23.5 lb-ft)
STEERING WHEEL AND COLUMN 3C-3