Switches - Suzuki sq-416-420-625 Service Manual

7A-6 MANUAL TRANSMISSION (TYPE 1)
1. Coupler
2. Clamp
1. Back up light switch
2. 4WD switch
1. Back up light switch coupler
2. Front propeller shaft

SWITCHES

TRANSFER 4WD SWITCH
1) Remove console box and lift transmission control lever boots
3, (a)
No. 2 and No. 3. (Refer to page 7A-4.)
2) Remove transfer control lever boot No. 2, unclamp wiring on
transfer case to free it and pull off coupler.
3. 4WD switch
4. Boot No. 2
3) Replace switch and connect as it was.
Tightening Torque
(a): 20 N
4) Turn ON ignition switch, shift transfer shift control lever to 4WD
position and check that indicator lights. Turn OFF switch after
checking.
NOTE:
D When removing and reinstalling switch, use care not to let
D Make sure to reset clamp for wiring which is located
D It is recommended to work on transfer shift control lever
D Identify this switch by its leg part which is different for that
BACK UP LIGHT SWITCH
WARNING:
Refrain from work while exhaust center pipe is hot.
REMOVAL AND INSTALLATION
NOTE:
When replacing switch, use care not to let dust enter transmis-
sion through switch hole.
1) Lift up vehicle.
2) Remove coupler(s) for switch wiring.
.
m (2.0 kg-m, 14.5 lb-ft)
dust enter transfer box inside.
where invisible directly.
boot No. 1 from underside of vehicle on lift.
of back up light switch.