Solenoid Valve - Suzuki GRAND VITARA XL-7 Owner's Manual

1B-32 AIR CONDITIONING (OPTIONAL)
4
2
5
1
1
3
1
7
6
3
(A)

Solenoid Valve

REMOVAL
1) Remove rear A/C unit referring to "REAR A/C UNIT" in this
section.
2) Disconnect solenoid valve connector (1).
3) Loosen solenoid valve flared nuts (2).
4) Remove solenoid valve bracket mounting screws (3), and
then remove rear liquid pipe (4) and rear suction pipe (5)
from rear expansion valve.
5) Remove rear liquid pipe (4), rear suction pipe (5) and sole-
noid valve bracket (6) from solenoid valve (7).
NOTE:
Cap open fitting immediately to keep moisture out of sys-
tem.
INSPECTION
1) Connect special tool to solenoid valve (1).
Special tool
(A) : 09917-47910
2) Check that solenoid valve is closed when vacuum is applied
to solenoid valve.
If solenoid valve is opened, replace solenoid valve.
3) Check that solenoid valve (1) is opened when connect bat-
tery to solenoid valve as shown in figure.
NOTE:
Solenoid valve terminal is no polarity.
INSTALLATION
Reverse removal procedure to install solenoid valve.