On" Steady - Suzuki GRAND VITARA XL-7 Owner's Manual

Table-E EBD Warning Lamp (Brake Warning Lamp) Check – Lamp Comes

"ON" Steady

CIRCUIT DESCRIPTION
EBD warning lamp (brake warning lamp) is controlled by parking brake switch, brake fluid level switch and ABS
control module/hydraulic unit assembly through lamp driver module in combination meter. Refer to "TABLE – A"
for circuit diagram.
INSPECTION
Step
1 1) Make sure that :
• Parking brake is completely released.
• Brake fluid level is upper than the minimum
level.
Are the check results OK?
2 Does "ABS" warning lamp come on?
3 1) Disconnect ABS hydraulic unit/control mod-
ule connector.
2) Check for proper connection to ABS
hydraulic unit/control module connector at
terminals "E136-10".
3) If OK, apply chocks to wheels and select
gear in neutral position (P range for A/T).
4) Keep brake pedal depressed and start
engine.
Release parking brake.
5) Connect terminal "E136-10" of discon-
nected connector to ground using service
wire.
Does EBD warning lamp (brake warning lamp)
turn off?
Action
ANTILOCK BRAKE SYSTEM (ABS) 5E2-19
Yes
Go to Step 2.
Perform "TABLE – B" pre-
viously outlined.
Substitute a known-good
ABS hydraulic unit/con-
trol module assembly and
recheck.
No
Release parking brake
completely and/or replen-
ish brake fluid.
Go to Step 3.
"BRN" circuit open.
If wire and connection are
OK, replace combination
meter.