Suzuki GRAND VITARA XL-7 Owner's Manual page 288

ENGINE MECHANICAL (H27 ENGINE)
WARNING:
For vehicles equipped with Supplemental Restraint (Air Bag) System:
• Service on and around the air bag system components or wiring must be performed only by an
authorized SUZUKI dealer. Refer to "Air Bag System Components and Wiring Location View" under
"General Description" in air bag system section in order to confirm whether you are performing ser-
vice on or near the air bag system components or wiring. Please observe all WARNINGS and "Ser-
vice Precautions" under "On-Vehicle Service" in air bag system section before performing service
on or around the air bag system components or wiring. Failure to follow WARNINGS could result in
unintentional activation of the system or could render the system inoperative. Either of these two
conditions may result in severe injury.
• Technical service work must be started at least 90 seconds after the ignition switch is turned to the
"LOCK" position and the negative cable is disconnected from the battery. Otherwise, the system
may be activated by reserve energy in the Sensing and Diagnostic Module (SDM).
NOTE:
• For the descriptions (items) not found in this section, refer to the same section of service manual
mentioned in the FOREWORD of this manual.
• Whether following systems (parts) are used in the particular vehicle or not depends on specifica-
tions. Be sure to bear this in mind when performing service work.
- EGR valve
- Warm up three way catalytic converter
- Heated oxygen sensor(s)
- Three way catalytic converter
- CKP sensor
- MAP sensor
On-Vehicle Service........................................6A2-2
Throttle Body and Intake Manifold ..............6A2-2
Exhaust Manifold.........................................6A2-9
LH (No.1) Bank 2nd Timing Chain
and Chain Tensioner .................................6A2-13
Camshaft and Valve Lash Adjuster ...........6A2-14
Valves and Cylinder Heads .......................6A2-17
Piston, Piston Rings, Connecting Rods
SECTION 6A2
CONTENTS
and Cylinders ............................................ 6A2-21
Unit Repair Overhaul .................................. 6A2-26
Engine Assembly ...................................... 6A2-26
Main Bearings, Crankshaft
and Cylinder Block .................................... 6A2-30
Special Tool................................................. 6A2-36
ENGINE MECHANICAL (H27 ENGINE) 6A2-1
6A2