6F2-10 IGNITION SYSTEM (FOR H27 ENGINE)
CMP Sensor
CAUTION:
Disassembly is prohibited. If anything faulty is found,
replace as an assembly unit.
REMOVAL
1) Disconnect CMP sensor coupler (2).
2) Remove A/T fluid level gauge and filler tube.
3) Remove CMP sensor (1) by removing bolt (3).
2
3
1
INSTALLATION
NOTE:
After installing CMP sensor, adjust ignition timing. (Refer
to "IGNITION TIMING CHECK AND ADJUSTMENT" in this
section).
1) Install a new O-ring (2) with engine oil applied to CMP sen-
sor (1).