Dtc P0155 Ho2S-1 (Bank 2) Heater Circuit Malfunction - Suzuki GRAND VITARA XL-7 Owner's Manual

6-1-70 ENGINE GENERAL INFORMATION AND DIAGNOSIS (H27 ENGINE)

DTC P0155 HO2S-1 (Bank 2) Heater Circuit Malfunction

WIRING DIAGRAM
Refer to DTC P0150.
DTC DETECTING CONDITION AND TROUBLE AREA
DTC DETECTING CONDITION
Following condition is detected when HO2S heater is
electrically live (2 driving cycle detection logic).
• Current of HO2S heater is 5.3 A or more or less than
0.09 A, or
• Voltage of HO2S heater is 14.0 V or higher or lower
than 11.7 V.
DTC CONFIRMATION PROCEDURE
NOTE:
Check to make sure that following conditions are satisfied when using this "DTC CONFIRMATION
PROCEDURE".
• Intake air temp. : – 8°C (18°F) or higher
• Engine coolant temp. : – 8 – 110°C (18 – 230°F)
• Altitude (barometric pressure) : 2400 m, 8000 ft or less (560 mmHg (75 kPa) or more)
1) Connect scan tool with ignition switch OFF.
2) Turn ON ignition switch and clear DTC, pending DTC and freeze frame data by using scan tool and run
engine at idle speed for 5 min.
3) Check pending DTC by using scan tool.
TROUBLESHOOTING
Step
1 Was "ENGINE DIAG. FLOW TABLE" per-
formed?
2 HO2S-1 heater check :
1) Disconnect HO2S-1 coupler with ignition
switch OFF.
2) Check resistance between "3" and "4" termi-
nal of HO2S-1 coupler.
HO2S-1 heater resistance :
5.0 – 6.4 Ω Ω Ω Ω (at 20°C (68°F))
Is it within above specification?
3 HO2S heater power supply check :
1) With ignition switch ON leaving engine OFF,
check voltage between E139-3 and ground,
E139-1 and ground. (See Fig.)
Is each voltage 10 – 14 V?
Action
TROUBLE AREA
HO2S-1 heater circuit
HO2S-1 heater
ECM (PCM)
Yes
Go to Step 2.
Go to Step 3.
Go to Step 4.
No
Go to "ENGINE
DIAG. FLOW TABLE" in
this section.
Replace HO2S-1.
"HO2S", and/or "IG
METER" fuse blown.
If OK, faulty "BLK/WHT"
wire or "BLU/WHT" wire.