Suzuki GRAND VITARA XL-7 Owner's Manual page 81

3C1-6 AIR BAG STEERING WHEEL AND COLUMN
1
3, (b)
"B"
"A"
2
1, (a)
3) Install steering column assembly (1) with contacting upper
side of lower bracket slits to mounting bolts. Tighten steering
column lower mounting nuts (3) first and then upper mount-
ing bolts (2) to specified torque.
Tightening torque
Steering column mounting bolts and nuts (b) :
25 N·m (2.5 kg-m, 18.0 lb-ft)
2, (b)
4) Align cutting point "A" of steering column assembly (1) with
bolt hole "B" of steering upper shaft upper joint as shown in
the figure. Then connect steering upper shaft upper joint.
1
5) Install steering upper shaft upper joint bolt (2) and nut (1).
Tighten steering upper shaft upper joint nut (1) to specified
torque.
Tightening torque
Steering upper shaft upper joint nut (a) :
23 N·m (2.3 kg-m, 17.0 lb-ft)
6) If contact coil and combination switch assembly is removed,
install it, referring to "CONTACT COIL AND COMBINATION
SWITCH ASSEMBLY" in this section.
7) Connect all connectors that have been removed in removal.
8) Install steering column hole cover (1).
9) If steering wheel is removed, install it by referring to
"STEERING WHEEL" in this section.
10) Connect negative (–) cable to battery.
11) After installing steering column assembly, be sure to enable
air bag system by referring to "ENABLING AIR BAG SYS-
TEM" under "SERVICE PRECAUTIONS" in Section 10B.