Stop Lamp Switch (With Pedal Position Switch) - Suzuki GRAND VITARA XL-7 Owner's Manual

8E-22 CRUISE CONTROL SYSTEM
Stop Lamp Switch (with Pedal Position
Switch)
INSPECTION
1) Disconnect negative (–) cable at battery.
2) Disconnect stop lamp switch connector and remove stop
lamp switch from pedal bracket.
3) Check switch (2 contacts) for resistance under each of the
following each conditions.
If check result is not satisfactory, replace stop lamp switch.
Stop lamp switch specification
Between terminals "1" and "3" (Contact for stop lamp)
FREE (2) : Continuity, PUSH (1) : No continuity
Between terminals "2" and "4" (Contact for brake pedal
position)
FREE (2) : No continuity, PUSH (1) : Continuity
4) Install stop lamp switch and adjust its position referring to
Section 5.