Dtc B1061 - "Air Bag" Warning Lamp Circuit Failure - Suzuki GRAND VITARA XL-7 Owner's Manual

Step
2 1) Inspect front of vehicle and undercar-
riage for signs of impact.
Are there signs of impact?
NOTE:
Upon completion of inspection and repair work, perform following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.
DTC B1061 – "AIR BAG" Warning Lamp Circuit Failure
WIRING DIAGRAM
BLK/BLU
1
2
1. From main fuse
2. Ignition switch
3. "IG METER" fuse
4. "AIR BAG" warning lamp in combination meter
CAUTION:
• Be sure to perform AIR BAG DIAGNOSTIC SYSTEM CHECK before starting diagnosis according to
flow table.
• When measurement of resistance or voltage is required in this table, use a tester along with a cor-
rect terminal adapter from special tool (Connector test adapter kit).
• When a check for proper connection is required, refer to INTERMITTENT AND POOR CONNEC-
TIONS in this section.
• If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
DTC WILL SET WHEN:
The voltage at the "AIR BAG" warning lamp circuit terminal "Q01-2" does not match the commanded state of the
warning lamp driver for specified time.
Action
5
BLU/BLK
BLK/WHT BLK/WHT
3
[A]
5. "AIR BAG" fuse
6. Connection detection pin
7. SDM
8. To DLC
Yes
Replace components and
perform inspections as
directed in REPAIRS AND
INSPECTIONS
REQUIRED AFTER AN
ACCIDENT in this section.
BLU/RED
BLU
4
PPL/RED
8
"G27"
9
10
"Q04"
11
9. To ECM, TCM (if equipped) and ABS control
module (if equipped)
10. "AIR BAG" monitor coupler
11. Ground for air bag system
[A]: Air bag harness
AIR BAG SYSTEM 10B-47
No
Substitute a known-good
SDM and recheck.
Q01-4 IG
BLU
Q01-2 LA
L1
6
L2
12V
PPL/RED
Q01-20 SDL
"Q02"
5V
PPL
Q01-15 DNS
BLK
Q01-17 GND
"Q01"
7