Suzuki GRAND VITARA XL-7 Owner's Manual page 307

6A2-20 ENGINE MECHANICAL (H27 ENGINE)
12) Install oil pan and oil pump strainer.
Refer to "OIL PAN AND OIL PUMP STRAINER" in this sec-
tion.
13) Install cylinder head cover.
Refer to "CYLINDER HEAD COVER" in this section.
14) Install exhaust manifold.
Refer to "EXHAUST MANIFOLD" in this section.
15) Install radiator outlet pipe, radiator, cooling fan and water
hose.
Refer to "COOLING WATER PIPES OR HOSES", "RADIA-
TOR" and "COOLING FAN AND FAN CLUTCH" in Section
6B.
16) Install throttle body and intake manifold.
Refer to "THROTTLE BODY AND INTAKE MANIFOLD" in
this section.
17) Adjust water pump drive belt tension.
Refer to "COOLING FAN BELT TENSION CHECK AND
ADJUSTMENT" in Section 6B.
18) Adjust power steering pump drive belt tension.
Refer to "POWER STEERING PUMP DRIVE BELT" in Sec-
tion 3B1.
19) Adjust accelerator cable play and A/T throttle cable play.
Refer to "ACCELERATOR CABLE ADJUSTMENT" and "A/T
THROTTLE CABLE ADJUSTMENT (A/T VEHICLE)" in Sec-
tion 6E2.
20) Check to ensure that all removed parts are back in place.
Reinstall any necessary parts which have not been rein-
stalled.
21) Refill engine with engine oil, referring to "ENGINE OIL
CHANGE" in Section 0B.
22) Refill cooling system referring to "COOLING SYSTEM
FLUSH AND REFILL" in Section 6B.
23) Refill front differential housing with gear oil if drained, refer-
ring to "MAINTENANCE SERVICE" in Section 7E.
24) Connect negative cable at battery.
25) Check ignition timing and adjust as necessary, referring to
"IGNITION TIMING CHECK AND ADJUSTMENT" in Section
6F2.
26) Verify that there is no fuel leakage, water leakage, oil leak-
age and exhaust gas leakage at each connection.
27) Check wheel alignment, referring to "STEERING ANGLE" in
Section 3A.