Suzuki GRAND VITARA XL-7 Owner's Manual page 157

5E2-32 ANTILOCK BRAKE SYSTEM (ABS)
2
1
3
(c)
3) Using special tool, loosen flare nuts (1) and disconnect brake
pipes (2) from ABS hydraulic unit/control module assembly
(3).
Special tool
09950-78220
NOTE:
Put bleeder plug cap onto pipe to prevent fluid from spill-
ing. Do not allow brake fluid to get on painted surfaces.
4) Remove three bolts and take out ABS hydraulic unit/control
module assembly (1) from bracket using flat end rod or the
like (2).
CAUTION:
• Do not give an impact to hydraulic unit.
• Use care not to allow dust to enter hydraulic unit.
• Do not place hydraulic unit on its side or upside down.
Handling it in inappropriate way will affect its original
performance.
INSTALLATION
1) Install hydraulic unit/control module assembly by reversing
removal procedure.
(a)
Tightening torque
Brake pipe flare nut (a) :
16 N·m (1.6 kg-m, 11.5 lb-ft)
ABS hydraulic unit/control module assembly bolt (b) :
9 N·m (0.9 kg-m, 6.5 lb-ft)
Bracket bolt (c) : 10 N·m (1.0 kg-m, 6.5 lb-ft)
2) Bleed air from brake system referring to "BRAKES" section.
3) Check each installed part for fluid leakage and perform "ABS
(b) HYDRAULIC UNIT OPERATION CHECK" in this section.
NOTE:
For new ABS hydraulic unit/control module assembly, if
"ABS HYDRAULIC UNIT OPERATION CHECK" procedure
(c) has not been performed, "ABS" warning lamp may flash
when ignition switch is turned ON position.
Accordingly preform "ABS HYDRAULIC UNIT OPERA-
TION CHECK" to stop flashing of ABS warning lamp.
(b)