Suzuki GRAND VITARA XL-7 Owner's Manual page 68

1, (a)
2
4) Install magnet clutch (1).
a) Set magnet clutch squarely over clutch installation boss.
b) Place special tool onto clutch bearing.
Ensure that edge rests only on inner race of bearing.
Special tool
(A) : 09991-06010
c) Install new circlip.
CAUTION:
Be careful not to scratch bearing seal.
5) Adjust clearance between armature plate (1) and magnet
1
clutch (2) by putting shim(s) on compressor shaft.
Standard clearance between armature plate and magnet
clutch "a" :
"a"
0.35 - 0.6 mm (0.014 - 0.023 in.)
2
6) Tighten new armature plate nut (1) to specified torque.
Tightening torque
Armature plate nut (a) :18 N·m (1.8 kg-m, 13.0 lb-ft)
Special tool
(A) : 09920-53740
(A)
2. Armature plate
7) Install compressor to vehicle. Refer to "COMPRESSOR
ASSEMBLY" in this section.
AIR CONDITIONING (OPTIONAL) 1B-43