Suzuki GRAND VITARA XL-7 Owner's Manual page 303

6A2-16 ENGINE MECHANICAL (H27 ENGINE)
6) Remove housing, and using scale (2) on gaging plastic (1)
envelop, measure gaging plastic (1) width at its widest point.
Camshaft journal clearance :
Standard : 0.045 – 0.099 mm (0.0018 – 0.0039 in.)
Limit : 0.12 mm (0.0047 in.)
If measured camshaft journal clearance exceeds limit, measure
journal (housing) bore and outside diameter of camshaft journal.
Replace camshaft or cylinder head assembly whichever the differ-
ence from specification is greater.
Camshaft journal bore dia. (IN & EX) :
Standard : 26.000 – 26.033 mm (1.0236 – 1.0249 in.)
Camshaft journal O.D. (IN & EX) :
Standard : 25.934 – 25.955 mm (1.0210 – 1.0218 in.)
Wear of hydraulic valve lash adjuster
Check adjuster for pitting, scratches, or damage.
If any malcondition is found, replace.
Measure cylinder head bore and adjuster outside diameter to
determine cylinder head-to-adjuster clearance. If clearance
exceeds limit, replace adjuster or cylinder head.
Hydraulic valve lash adjuster O.D. :
Standard : 30.959 – 30.975 mm (1.2188 – 1.2194 in.)
Cylinder head bore :
Standard : 31.000 – 31.025 mm (1.2205 – 1.2214 in.)
Cylinder head to adjuster clearance :
Standard : 0.025 – 0.066 mm (0.0010 – 0.0025 in.)
Limit : 0.15 mm (0.0059 in.)