Suzuki GRAND VITARA XL-7 Owner's Manual page 593

10B-16 AIR BAG SYSTEM
Table A - "AIR BAG" Warning Lamp Comes ON Steady
Table B - "AIR BAG" Warning Lamp Does Not Come ON
Table C - "AIR BAG" Warning Lamp Flashes
Table D - "AIR BAG" Warning Lamp Cannot Indicate Flashing Pattern of DTC
WIRING DIAGRAM
BLK/BLU
1
2
1. From main fuse
2. Ignition switch
3. "IG METER" fuse
4. "AIR BAG" warning lamp in combination meter
CAUTION:
• Be sure to perform AIR BAG DIAGNOSTIC SYSTEM CHECK before starting diagnosis according to
flow table.
• When measurement of resistance or voltage is required in this table, use a tester along with a cor-
rect terminal adapter from special tool (Connector test adapter kit).
• When a check for proper connection is required, refer to INTERMITTENT AND POOR CONNEC-
TIONS in this section.
• If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
5
BLU/BLK
BLK/WHT BLK/WHT
3
8
[A]
5. "AIR BAG" fuse
6. Connection detection pin
7. SDM
8. To DLC
BLU/RED
BLU
BLU
4
6
PPL/RED
PPL/RED
Q01-20
"G27"
"Q02"
9
PPL
Q01-15
10
"Q04"
BLK
Q01-17
11
"Q01"
9. To ECM, TCM (if equipped) and ABS control
module (if equipped)
10. "AIR BAG" monitor coupler
11. Ground for air bag system
[A]: Air bag harness
Q01-4 IG
Q01-2
LA
L1
L2
12V
SDL
5V
DNS
GND
7