Line Pressure Test - Suzuki GRAND VITARA XL-7 Owner's Manual

Line Pressure Test

Purpose of this test is to check operating conditions of each part
by measuring fluid pressure in fluid pressure line. Line pressure
test requires following conditions.
• Automatic fluid is at normal operating temperature (70 to 80
° C/158 – 176 °F).
• Fluid is filled to proper level (between FULL HOT and LOW
HOT on dipstick).
1) Apply parking brake securely and place checks against
wheels.
2) Attach oil pressure gauge to fluid pressure check hole (1) in
transmission case.
Special tool
(A) : 09925-37811-001
CAUTION:
After attaching oil pressure gauge, check that not fluid
leakage exists.
3) Depress foot brake fully, run engine at idle and stall.
4) Check fluid pressure in "D" or "R" range within the following
specification.
CAUTION:
Do not continue running engine at stall speed longer
than 5 seconds.
Line pressure :
"D" range
Idle speed
4.1 – 4.6 kg/cm
58 – 65 psi
Stall speed
12.0 – 13.5 kg/cm
171 – 192 psi
5) If check result is OK, disconnect special tool, then tighten
transmission case plug to specified torque.
Tightening torque
Transmission case plug : 17 N·m (1.7 kg-m, 12.0 lb-ft)
AUTOMATIC TRANSMISSION (4 A/T) 7B1-39
"R" range
2
5.4 – 6.0 kg/cm
77 – 85 psi
2
14.6 – 17.1 kg/cm
208 – 243 psi
2
2