Suzuki GRAND VITARA XL-7 Owner's Manual page 596

[A] Fig. for STEP 2/[B] Fig. for STEP 3 and 5/[C] Fig. for STEP 4
1. 16-pin connector (for combination meter)
2. "BLU" wire terminal
Special tool
(A) : 09932-75020
NOTE:
Upon completion of inspection and repair work, perform following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.
Table C :
Step
1 1) Check "AIR BAG" monitor coupler.
Is it connected diagnosis switch terminal in "AIR
BAG" monitor coupler and body ground by ser-
vice wire?
2 1) With ignition switch OFF, disconnect SDM
connector.
2) Measure resistance between "Q01-15" ter-
minal of SDM connector and body ground.
Is circuit open?
Fig. for STEP 2
NOTE:
Upon completion of inspection and repair work, perform following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.
Action
Special tool
(A) : 09932-75020
Yes
Remove service wire.
Substitute a known-good
SDM and recheck.
AIR BAG SYSTEM 10B-19
No
Go to step 2.
Repair short from "PPL"
wire circuit to ground.