Suzuki GRAND VITARA XL-7 Owner's Manual page 501

7F-16 DIFFERENTIAL (REAR)
6) Select adjusting shim(s) (2) closest to calculated value from
among following available sizes and put it in place and then
press-fit rear bearing (1).
Calculated valve
"f" : Closest value to "e" (refer to Step 5).)
Special tool
(G) : 09925-18011
(H) : 09927-66010
Available shim thickness
: 1.12, 1.15, 1.18, 1.21,1.24, 1.27, 1.30 and 0.3 mm
(0.044, 0.045, 0.046, 0.047 0.048, 0.049, 0.050 and 0.012 in.)
3. Drive bevel pinion
7) With new pinion spacer (3) inserted as shown in the figure,
install front bearing (5) to differential carrier (4).
NOTE:
• Make sure to use new spacer for reinstallation.
• Apply differential oil to bearings.
1. Drive bevel pinion
2. Rear bearing
8) Using special tool and plastic hammer, drive oil seal (2) into
differential carrier (1) till it becomes flush with carrier end.
Then apply grease "A" to oil seal lip.
"A" : Grease 99000-25010
Special tool
(I) : 09951-18210