Evap Canister Purge System Inspection; Vacuum Passage Inspection - Suzuki GRAND VITARA XL-7 Owner's Manual

6-1-100 ENGINE GENERAL INFORMATION AND DIAGNOSIS (H27 ENGINE)
1

Evap canister purge system inspection

1) Warm up engine to normal operating temperature.
2) Hoist vehicle so that all wheels rotate freely.
3) Set M/T in "Neutral" or A/T in "P" position and parking brake.
4) Disconnect purge hose (1) from EVAP canister.
5) Place finger against the end of disconnected hose (1) and
check that vacuum is not felt there when engine is running at
idle speed.
6) Release parking brake lever, set transfer in "2H" and M/T in
"1st" or A/T in "L".
WARNING:
Make sure that transfer is set to "2H" range position for
this check. If it is set to "4H" or "4L" position, front and
rear wheels turn at high speed and a very dangerous sit-
uation may occur.
7) Also check that vacuum is felt when engine speed is
increased to higher than about 1,500 r/min. and keep it for 3
min. or more. If check result is not described in steps 5) and
7), check EVAP canister purge valve, wire harness and vac-
uum passage.

Vacuum passage inspection

Start engine and run it at idle speed. With finger placed against
vacuum nozzle (1), check that vacuum is applied.
If it is not applied, clean vacuum passage by blowing compressed
air.