Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
For error frame seconds event, configure the error threshold as 8 and the event
detection interval as 30 seconds on Gigabit Ethernet port 5:
T2600G-28TS(config)# interface gigabitEthernet 1/0/5
T2600G-28TS(config-if)#
threshold 8 window 300
ethernet-oam remote-failure
35.7
Description
The ethernet-oam remote-failure command is used to configure whether to
notify the link faults or not. The link faults include dying gasp and critical event.
To return to the default configurations, please use no ethernet-oam
remote-failure command.
Syntax
ethernet-oam remote-failure { dying-gasp | critical-event } notify { disable |
enable }
no ethernet-oam remote-failure { dying-gasp | critical-event } notify
Parameter
dying-gasp —— Dying Gasp link event. Dying gasp means an unrecoverable
fault, such as power failure, occurs.
critical-event —— Critical Event. Critical-event means unspecified critical event
occurs.
notify ——Enable/Disable the event notification. By default, it is enabled.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
ethernet-oam
link-monitor
285
frame-seconds