Ethernet-Oam Link-Monitor Frame-Period - TP-Link T2600G-28TS Reference Manual

notify —— Enable/Disable the event notification. By default, it is enabled.
threshold | window | notify —— The parameter that you want to return to the
default configuration.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
For error frame event, configure the error threshold as 6 and the event detection
interval as 9 seconds on Gigabit Ethernet port 1/0/3:
T2600G-28TS(config)# interface gigabitEthernet 1/0/3
T2600G-28TS(config-if)# ethernet-oam link-monitor frame threshold 6
window 90

ethernet-oam link-monitor frame-period

35.5
Description
The ethernet-oam link-monitor frame-period command is used to configure
the parameters about one of the link events, error frame period event. To return
to the default configurations, please use no ethernet-oam link-monitor
frame-period command.
Syntax
ethernet-oam link-monitor frame-period { [threshold threshold ] [ window
window ] [notify { disable | enable } ] }
no ethernet-oam link-monitor frame-period { threshold | window | notify }
Parameter
threshold —— Configure the error threshold for generating error frame period
event. The range is from 1 to 4294967295 and the default value is 1.
window —— Configure the error frame period event detection interval. The
range is from 148810 to 89286000. The default value is 148810 for Fast
Ethernet port and 1488100 for Gigabit Ethernet port.
notify —— Enable/Disable the event notification. By default, it is enabled.
283