TP-Link T2600G-28TS Reference Manual page 325

snooping multi-vlan-config command. To restore the default values, please
use no ip igmp snooping multi-vlan-config with specified parameters.
Syntax
ip igmp snooping multi-vlan-config [ vlan-id ] [ rtime router-time | mtime
member-time | rport interface { gigabitEthernet port-list | port-channel
port-channel-id } ]
no ip igmp snooping multi-vlan-config [ rtime router-time | mtime
member-time | rport interface { gigabitEthernet port-list | port-channel
port-channel-id } ]
Parameter
vlan-id —— The ID of the multicast VLAN desired to create or modify, ranging
from 2 to 4094. If not specified, the default multicast VLAN will be selected.
router-time —— Router Port Time. Within this time, if the switch does not
receive IGMP query message from the router port, it will consider this port is not
a router port any more. Router Port Time ranges from 60 to 600 in seconds. By
default, it is 0 and the global router-time will be used.
member-time —— Member Port Time. Within this time, if the switch does not
receive IGMP report message from the member port, it will consider this port is
not a member port any more. Member Port Time ranges from 60 to 600 in
seconds. By default, it is 0 and the global member-time will be used.
port-list —— The list of Ethernet ports.
port-channel-id —— The ID of the port channels.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Enable Multicast VLAN 3, and configure Router Port Time as 100 seconds,
Member Port Time 100 seconds, and Static Router Port port 1/0/3:
T2600G-28TS(config)# ip igmp snooping multi-vlan-config 3 rtime 100
T2600G-28TS(config)# ip igmp snooping multi-vlan-config 3 mtime 100
T2600G-28TS(config)# ip igmp snooping multi-vlan-config 3 rport
interface gigabitEthernet 1/0/3
305