Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the hold-count of STP as 8pps:
T2600G-28TS(config)# spanning-tree hold-count 8
spanning-tree max-hops
34.16
Description
The spanning-tree max-hops command is used to configure the maximum
number of hops that occur in a specific region before the BPDU is discarded. To
return to the default configurations, please use no spanning-tree max-hops
command.
Syntax
spanning-tree max-hops value
no spanning-tree max-hops
Parameter
value —— The maximum number of hops that occur in a specific region before
the BPDU is discarded, ranging from 1 to 40 in hop. By default, it is 20.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the max-hops of STP as 30:
T2600G-28TS(config)# spanning-tree max-hops 30
spanning-tree bpdufilter
34.17
Description
The spanning-tree bpdufilter command is used to enable the BPDU filter
function for a port. With the function enabled, the port can be prevented from
receiving and sending any BPDU packets. To disable the BPDU filter function,
please use no spanning-tree bpdufilter command.
272