TP-Link T2600G-28TS Reference Manual page 323

Parameter
vlan-id-list —— The ID list of the VLAN desired to modify configuration, ranging
from 1 to 4094, in the format of 1-3, 5.
router-time —— Router Port Time. Within this time, if the switch does not
receive IGMP query message from the router port, it will consider this port is not
a router port any more. Router Port Time ranges from 60 to 600 in seconds. By
default, it is 0 and the global router-time will be used.
member-time —— Member Port Time. Within this time, if the switch does not
receive IGMP report message from the member port, it will consider this port is
not a member port any more. Member Port Time ranges from 60 to 600 in
seconds. By default, it is 0 and the global member-time will be used.
port-list —— The list of Ethernet ports.
port-channel-id —— The ID of the port channels.
ip —— The static multicast IP address.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the IGMP Snooping function and modify Router Port Time as 300
seconds, Member Port Time as 200 seconds for VLAN 1-3, and set the router
port as 1/0/1 for VLAN 1-2:
T2600G-28TS(config)# ip igmp snooping vlan-config 1-3 rtime 300
T2600G-28TS(config)# ip igmp snooping vlan-config 1-3 mtime 200
T2600G-28TS(config)# ip igmp snooping vlan-config 1-2 rport interface
gigabitEthernet 1/0/1
Add static multicast IP address 225.0.0.1, which corresponds to VLAN 2, and
configure the forward ports as ports 1/0/1-3:
T2600G-28TS(config)# ip igmp snooping vlan-config 2 static 225.0.0.1
interface gigabitEthernet 1/0/1-3
303