TP-Link T2600G-28TS Reference Manual page 37

Interface Configuration Mode can also be divided into Interface Ethernet, Interface
link-aggregation and some other modes, which is shown as the following diagram.
The following table gives detailed information about the Accessing path, Prompt of each mode and
how to exit the current mode and access the next mode.
Mode Accessing Path
User EXEC
Primary mode once it
is connected with the
Mode
switch.
Use the enable
Privileged
command to enter this
mode from User
EXEC Mode
EXEC mode.
Use the configure
Global
command to enter this
Configuration
mode from Privileged
Mode
EXEC mode.
Layer 2 Interface:
Use the interface
gigabitEthernet port,
interface
port-channel
Interface
port-channel-id or
Configuration
interface range
Mode
gigabitEthernet
port-list command to
enter this mode from
Global Configuration
mode.
Prompt
T2600G-28TS>
T2600G-28TS#
T2600G-28TS(config)#
T2600G-28TS (config-if)#
or
T2600G-28TS(config-if-range)#
17
Logout or Access the next
mode
Use the exit command to
disconnect the switch.
Use the enable command to
access Privileged EXEC mode.
Enter the disable or the exit
command to return to User EXEC
mode.
Enter configure command to
access Global Configuration
mode.
Use the exit or the end command
or press Ctrl+Z to return to
Privileged EXEC mode.
Use the interface
gigabitEthernet port or interface
range gigabitEthernet port-list
command to access interface
Configuration mode.
Use the vlan vlan-list to access
VLAN Configuration mode.
Use the end command or press
Ctrl+Z to return to Privileged
EXEC mode.
Enter the exit or the # command
to return to Global Configuration
mode.
A port number must be specified in
the interface command.