Chapter 41 sFlow Commands
sFlow (Sampled Flow) is a technology for accurately monitoring network traffic at high speeds.
The sFlow monitoring system consists of an sFlow agent (embedded in a switch or router or in a
standalone probe) and a central sFlow collector. The sFlow agent is a virtual entity using sampling
technology to capture traffic statistics from the device it is monitoring. The sFlow collector can be a
host receiving sFlow datagrams from the sFlow agent.
The sFlow function is implemented as follows: the sFlow sampler take samples of traffic statistics
and send sFlow datagrams to the sFlow agent for processing. The sFlow agent will forward sFlow
datagrams to the sFlow collector for analysis. The analytic results can be displayed on the sFlow
collector.
sflow address
41.1
Description
The sflow address command is used to configure the sFlow agent's IP address.
To delete the configured address, please use no sflow address command.
Syntax
sflow address { ipv4-addr }
no sflow address { ipv4-addr }
Parameter
ipv4-addr ——The IP address of the sFlow agent. The type of the IP address
should be IPv4. For example, you can set the switch's management IP as the IP
address of the sFlow agent.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Configure the sFlow agent with the IP address as 192.168.0.1:
T2600G-28TS(config)#sflow address 192.168.0.1
372