Access-List Ipv6 - TP-Link T2600G-28TS Reference Manual

address mask is 255.255.255.0, the time-range for the rule to take effect is
"tSeg1", and the packets match this rule will be forwarded by the switch:
T2600G-28TS(config)# access-list create 2700
T2600G-28TS(config)# access-list combined 2700 rule 10 permit smac
00:01:3F:48:16:23 smask 11:11:11:11:11:00 sip 192.168.0.100 sip-mask
255.255.255.0 tseg tSeg1

access-list ipv6

33.11
Description
The access-list ipv6 command is used to add IPv6 ACL rule. To delete the
corresponding rule, please use no access-list ipv6 command. Standard-IP
ACLs analyze and process data packets based on a series of match conditions,
which can be the source IP addresses and destination IP addresses carried in
the packets, the DSCP and flow-label value, etc.
Syntax
access-list ipv6 acl-id rule rule-id { deny | permit } [dscp dscp-value]
[flow-label flow-label-value] [ [ sip source-ip ] sip-mask source-ip-mask] [ [ dip
destination-ip ] dip-mask destination-ip-mask ] [ s-port s-port ] [ d-port d-port ]
[ tseg time-segment ]
no access-list ipv6 acl-id rule rule-id
Parameter
acl-id —— The desired Standard-IP ACL for configuration.
rule-id —— The rule ID.
deny —— The operation to discard packets.
permit ——The operation to forward packets. It is the default value.
dscp-value —— Specify the dscp value, ranging from 0 to 63.
flow-label-value —— The IPv6 flow label, which ranges from 0-0xfffff.
source-ip —— The source IP address contained in the rule.
source-ip-mask —— The source IP address mask. It is required if you typed the
source IP address.
destination-ip —— The destination IP address contained in the rule.
destination-ip-mask —— The destination IP address mask. It is required if you
typed the destination IP address.
s-port —— The source port number.
250