Access-List Combined - TP-Link T2600G-28TS Reference Manual

protocol —— Configure the value of the matching protocol.
tos —— Enter the IP ToS contained in the rule.
pre —— Enter the IP Precedence contained in the rule.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Create an Extended-IP ACL whose ID is 2220, and add Rule 10 for it. In the rule,
the source IP address is 192.168.0.100, the source IP address mask is
255.255.255.0, the time-range for the rule to take effect is tSeg1, and the
packets match this rule will be forwarded by the switch:
T2600G-28TS(config)# access-list create 2220
T2600G-28TS(config)# access-list extended 2220 rule 10 permit sip
192.168.0.100 smask 255.255.255.0 tseg tSeg1

access-list combined

33.10
Description
The access-list combined command is used to add Combined ACL rule. To
delete the corresponding rule, please use no access-list combined command.
Combined ACLs analyze and process data packets based on a series of match
conditions.
Syntax
access-list combined acl-id rule rule-id { deny | permit }
source-mac ] smask source-mac-mask ] [ [ dmac destination-mac ] dmask
destination-mac-mask ] [ vid vlan-id ] [ type ethernet-type ] [ pri user-pri ] [ [ sip
source-ip ] sip-mask source-ip-mask ] [ [ dip destination-ip ] dip-mask
destination-ip-mask ] [ tseg time-segment ]
no access-list combined acl-id rule rule-id
Parameter
acl-id —— The desired Standard-IP ACL for configuration.
rule-id —— The rule ID.
deny —— The operation to discard packets.
248
[ [ smac