Preface - TP-Link T2600G-28TS Reference Manual

Preface

This Guide is intended for network administrator to provide referenced information about CLI
(Command Line Interface). The device mentioned in this Guide stands for T2600G-28TS/
T2600G-52TS JetStream Gigabit L2 Managed Switch without any explanation. The commands in
this guilde apply to these models if not specially noted, and T2600G-28TS is taken as an example
model in the example commands.
Overview of this Guide
Chapter 1: Using the CLI
Provide information about how to use the CLI, CLI Command Modes, Security Levels and some
Conventions.
Chapter 2: User Interface
Provide information about the commands used to switch between five CLI Command Modes.
Chapter 3: IEEE 802.1Q VLAN Commands
Provide information about the commands used for configuring IEEE 802.1Q VLAN.
Chapter 4: MAC-based VLAN Commands
Provide information about the commands used for configuring MAC-based VLAN.
Chapter 5: Protocol VLAN Commands
Provide information about the commands used for configuring Protocol VLAN.
Chapter 6: VLAN-VPN Commands
Provide information about the commands used for configuring VLAN-VPN (Virtual Private Network)
function.
Chapter 7: Private VLAN Commands
Provide information about the commands used for configuring Private VLAN.
Chapter 8: L2PT Commands
Provide information about the commands used for configuring L2PT (Layer 2 Portocol Tunneling).
Chapter 9: GVRP Commands
Provide information about the commands used for configuring GVRP (GARP VLAN registration
protocol).
Chapter 10: Voice VLAN Commands
Provide information about the commands used for configuring Voice VLAN.
Chapter 11: Etherchannel Commands
Provide information about the commands used for configuring LAG (Link Aggregation Group) and
LACP (Link Aggregation Control Protocol).
1