Ethernet-Oam Remote-Loopback Received-Remote- Loopback - TP-Link T2600G-28TS Reference Manual
Jetstream gigabit l2 managed switch
Hide thumbs
Also See for T2600G-28TS:
- User manual (355 pages) ,
- Installation manual (32 pages) ,
- Installation manual (32 pages)
Table of Contents
Advertisement
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Disable the Dying Gasp link event notification on Gigabit Ethernet port 1/0/7:
T2600G-28TS(config)# interface gigabitEthernet 1/0/7
T2600G-28TS(config-if)# ethernet-oam remote-failure dying-gasp notify
disable
ethernet-oam remote-loopback received-remote-
35.8
loopback
Description
The ethernet-oam remote-loopback received-remote-loopback command is
used to configure the client to process or to ignore the received remote
loopback request. To return to the default configurations, please use no
ethernet-oam remote-loopback received-remote-loopback command.
Syntax
ethernet-oam remote-loopback received-remote-loopback { process |
ignore }
no ethernet-oam remote-loopback received-remote-loopback
Parameter
process —— Process the received remote loopback request.
ignore —— Ignore the received remote loopback request.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Configure the client to process the received remote loopback request on Gigabit
Ethernet port 1:
286
Hide quick links:
Advertisement
Table of Contents
