Example
Enable MLD Snooping on port 1/0/3:
T2600G-28TS(config)# interface gigabitEthernet 1/0/3
T2600G-28TS(config-if)# ipv6 mld snooping
ipv6 mld snooping rtime
38.3
Description
The ipv6 mld snooping rtime command is used to specify router port aging
time globally. To restore the default timer, please use no ipv6 mld snooping
rtime command.
Syntax
ipv6 mld snooping rtime rtime
no ipv6 mld snooping rtime
Parameter
rtime —— Specify the aging time in seconds, ranging from 60 to 600. The
default aging time is 300 seconds.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Specify MLD Snooping router port aging time as 100 seconds globally:
T2600G-28TS(config)# ipv6 mld snooping rtime 100
ipv6 mld snooping mtime
38.4
Description
The ipv6 mld snooping mtime command is used to specify member port aging
time globally. The default aging time is 260 seconds. To restore the default timer,
please use no ipv6 mld snooping mtime command.
Syntax
ipv6 mld snooping mtime mtime
no ipv6 mld snooping mtime
Parameter
mtime —— Specify the aging time in seconds, ranging from 60 to 600. The
default aging time is 260 seconds.
321