Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Specify MLD Snooping member port aging time as 100 seconds globally:
T2600G-28TS(config)# ipv6 mld snooping mtime 100
ipv6 mld snooping report-suppression
38.5
Description
The ipv6 mld snooping report-suppression command is used enable the
MLD report suppression function. When it is enabled, the switch forwards only
the first MLD report message per mulicast group to the Layer 3 device, and the
subsequent MLD reports from the same multicast group are discarded. To
disable the MLD report suppression function and forward all the MLD reports to
the Layer 3 device, please use no ip igmp snooping report-suppression
command. This function is disabled by default.
Syntax
ipv6 mld snooping report-suppression
no ipv6 mld snooping report-suppression
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Enable MLD Report message suppression function:
T2600G-28TS(config)# ipv6 mld snooping report-suppression
ipv6 mld snooping immediate-leave
38.6
Description
The ipv6 mld snooping immediate-leave command is used to configure the
Fast Leave function for port. To disable the Fast Leave function, please use no
ipv6 mld snooping immediate-leave command.
322