Ipv6 Mld Snooping Multi-Vlan-Config (Source-Ip-Replace) - TP-Link T2600G-28TS Reference Manual

Privilege Requirement
Only Admin level users have access to these commands.
Example
Forbid the Ethernet ports 1/0/1-3 as being router ports in multicast VLAN 1 :
T2600G-28TS(config)# ipv6 mld snooping multi-vlan-config 1
router-port-forbidd interface gigabitEthernet 1/0/1-3
ipv6 mld snooping multi-vlan-config
38.14
(source-ip-replace)
Description
This command is used to replace the multicast source IP address of the MLD
packets in the specified multicast VLAN. To delete the forbidden router ports,
please use no ipv6 mld snooping multi-vlan-config replace-sourceip
command.
Syntax
ipv6 mld snooping multi-vlan-config [ vlan-id ] replace-sourceip ip
no ipv6 mld snooping multi-vlan-config replace-sourceip
Parameter
vlan-id—— The ID of the multicast VLAN.
ip —— Specify the IP address. The switch will use this IP address to replace the
source IP address of the MLD packets.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Replace the source IP address of the MLD packets in multicast VLAN 1 as
fe80::02ff:ffff:fe00:0001:
T2600G-28TS(config)# ipv6 mld snooping multi-vlan-config 1
replace-sourceip fe80::02ff:ffff:fe00:0001
329