Ethernet-Oam Link-Monitor Frame-Seconds - TP-Link T2600G-28TS Reference Manual

threshold | window | notify —— The parameter that you want to return to the
default configuration.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
For error frame period event, configure the error threshold as 6 and the event
detection interval as 150000 frames on Gigabit Ethernet port 1/0/4:
T2600G-28TS(config)# interface gigabitEthernet 1/0/4
T2600G-28TS(config-if)#
threshold 6 window 150000

ethernet-oam link-monitor frame-seconds

35.6
Description
The ethernet-oam link-monitor frame-seconds command is used to configure
the parameters about one of the link events, error frame seconds event. To
return to the default configurations, please use no ethernet-oam link-monitor
frame-seconds command.
Syntax
ethernet-oam link-monitor frame-seconds { [threshold threshold ] [ window
window ] [notify { disable | enable } ] }
no ethernet-oam link-monitor frame-seconds { threshold | window | notify }
Parameter
threshold —— Configure the error threshold for generating error frame seconds
event. The range is from 1 to 900 and the default value is 1.
window —— Configure the error frame seconds event detection interval. The
range is from 100 to 9000, in terms of 100 ms intervals. The default value is 600.
notify —— Enable/Disable the event notification. By default, it is enabled.
threshold | window | notify —— The parameter that you want to return to the
default configuration.
ethernet-oam link-monitor
284
frame-period